KNX Cover

The knx cover platform is used as in interface with KNX covers.

The knx component must be configured correctly, see KNX Component.

To use your KNX covers in your installation, add the following to your configuration.yaml file:

# Example configuration.yaml entry
cover:
    - platform: knx
      name: "Kitchen.Shutter"
      move_long_address: '3/0/0'
      move_short_address: '3/0/1'
      position_address: '3/0/3'
      position_state_address: '3/0/2'
      travelling_time_down: 51
      travelling_time_up: 61

name (Optional): A name for this device used within Home Assistant.
move_long_address: KNX group address for moving the cover full up or down.
move_short_address: (Optional) KNX group address for moving the cover short time up or down.
position_address: (Optional) KNX group address for moving the cover to the dedicated position.
position_state_address: (Optional) Separate KNX group address for requesting the current position of the cover.
angle_address: (Optional) KNX group address for moving the cover to the dedicated angle.
angle_state_address: (Optional) Separate KNX group address for requesting the current angle of cover.
travelling_time_down: (Optional) Time cover needs to travel down in seconds. Needed to calculate the intermediate positions of cover while traveling. Defaults to 25.
travelling_time_up: (Optional) Time cover needs to travel up in seconds. Needed to calculate the intermediate positions of cover while traveling. Defaults to 25.
invert_position: (Optional) Set this to true if your actuator report fully closed as 100%
invert_angle: (Optional) Set this to true if your actuator reports tilt fully closed as 100%