KNX Light

The knx light component is used as in interface to switching/light actuators.

The knx component must be configured correctly, see KNX Component.

To use your KNX light in your installation, add the following lines to your configuration.yaml file:

light:
  - platform: knx
    name: Kitchen-Light-1
    address: '1/0/9'
    brightness_address: '1/0/11'

  - platform: knx
    name: Kitchen-Light-2
    address: '1/0/12'
    brightness_address: '1/0/14'

• name (Optional): A name for this device used within Home Assistant.
• address: KNX group address for switching the light on and off
• brightness_address: (Optional) KNX group address for dimming light.
• state_address: (Optional) separate KNX group address for retrieving the switch state of the light.
• brightness_state_address: (Optional) separate KNX group address for retrieving the dimmed state of the light.

Some KNX devices can change their state internally without any messages on the KXN bus, e.g., if you configure a timer on a channel. The optional state_address can be used to inform Home Assistant about these state changes. If a KNX message is seen on the bus addressed to the given state address, this will overwrite the state of the switch object. For switching/light actuators that are only controlled by a single group address and can’t change their state internally, you don’t have to configure the state address.